Moisture ingress

Paint Check Plus > Wood > Moisture ingress

Moisture ingress


Old defective putties allowing moisture ingress into the timber resulting in the wood splitting and corrosion of the glazing pins.


Hack out the old putties and replace after priming the rebates. Burn off remaining paint coatings followed by thoroughly sanding down, clean nail heads or replace.

Treat knots, etc. if present and prime overall. A general  purpose primer suitable for wood and metal is usually recommended as this will contain rust inhibitive pigments.

This should be followed by an undercoat and finishing system oil or water based.

You cannot copy content of this page

Privacy Preference Center